Back in February of 2020 we received a call from Bishop Little of Ebenezer Baptist Church in Los Angeles. Ebenezer Baptist Church was built in 1938, in South Los Angeles.The Bishop inquired if we would come out to take a look at the church stained glass windows. The windows were sagging and pieces were cracking. We made an appointment for the following week.
Windows with exterior acrylic before
There are four stained glass windows two are 42" wide and 10 feet tall , and the other two are 42" wide and 12 feet tall. The windows are composed of 4 sections each. All the windows had very crazed and hazy acrylic on the exterior for protective glazing. On the interior there was obvious slipping of the window. The bottom panels had cracks, and the lower borders had folded. Two of the bottom panels had gaps on top of up to 1". The panels three panels above the bottom panels were in fairly good condition.
The Church wanted to conserve money(not unheard of), so I proposed that we remove and restore the four bottom panels and leave the upper panels. We would remove the exterior acrylic and replace it with clear 1/4" tempered glass. It was also obvious that all the exterior woodwork would need to be replaced as it was severely weather beaten and had obvious rot. I presented a proposal to replace, and paint all the exterior wood(leaving the sash and frames), restore the four lower panels, and install the tempered glass. The proposal was accepted, and we scheduled the work. Unfortunately, the Cocid-19 pandemic struck at this time. It wasn't until late July that we were able to begin work.
Deterioration of frame and sash, sagging of window
We removed the exterior acrylic and observed just how bad the frames and sash really were. There was extensive dry rot, and total deterioration of most of the frames. The steel T bars that were supporting the windows were tearing away from the sash. The sill was almost totally useless. We now proposed that we replace the entire set of four window frames and sash. We opened up the wall of the inside and saw that the studs were rotted and the entire wall was like jelly. We would have to rebuild the entire wall. With my friend and contractor Don Van Cura we proceeded. We ordered the frames and sash, and removed all the stained glass panels, and deteriorated frames and sash. Then we boarded up the opening with plywood for four weeks while we waited for the new frames and sash to arrive.
Wall with old frame and studs removed Wall with old studs Exterior showing frame removed
Wall with dry wall and frame installed
With the frames due to arrive we began rebuilding the walls. Don Van Cura was able to cut the old studs away from the exterior stucco with a Sawzall, and set in new 2 x 4's. He then miraculously screwed the existing stucco to the new 2 x 4's setting in flashing paper and caulking. With the new frames and sash in hand he began installation continuing with the fascia trim, and caulking the complete set of windows. He patched up the stucco, and Ron Benveniste of R.B Painting Company, primed all the woodwork interior and exterior.and we were ready to install the stained glass panels.
Installing T bar Windows installed
The first step was to set all the original steel T bars in place. We previously cleaned them up and painted them. The bars had a 90 degree bend at each end, and we screwed them in place into the sash. Each bar was spaced to allow for the stacking of glass panels , but each would support their panel separately. With the T bars installed to set the panels in place securing them with steel sash clips, and wood molding. We completed the window installation, and came back after the painters painted the stucco, and interior and exterior of the woodwork. They did a fabulous job in color matching the stucco and frame color. The original color was from 1938.
Exterior with Tempered Glass Finished Restoration from inside
When the final painting was completed we went back and installed the tempered glass exterior glazing. We decided to cover each window with a single piece of glass rather than 4 separate pieces as was originally there. The final result met with many thanks, and much love. It is always such a wonderful feeling to restore beautiful windows and bring them to life once again. The spiritual feeling from the congregation, Bishop, and ourselves is a tremendous reward. During the whole process we feel a kinship with the original artisans that created these windows to so long ago. It's a nice way to honor them as well. Now the church will have these beautiful windows for many generations to come.
Comments
You can follow this conversation by subscribing to the comment feed for this post.